Your selection of interfaces


The interfaces allows the TraceBox flexible deployment options and enables all the features of modern and customized motor control software development. To protect internal microcontrollers a grounding concept isolates certain interfaces of the TraceBox.

DUT Interfaces


  • JTAG/SWD interface according to the XMC™ Link interface
  • Isolated SPI, UART or PWM connection with pre-assembled ribbon cable



The TraceBox provides small connectors with various interfaces towards the DUT electronics. The pin mapping of the JTAG/SWD interface is created according to the XMC™ Link interface. Alternatively, the SWD pins of the JTAG/SWD connector are available on the MTN DUT connector. With the pre-assembled ribbon cable, it is also possible to easily realize isolated SPI, UART or PWM connection. In case of using the SPI interface, the TraceBox acts as a slave. Due to small space requirement and different design variants, the connector is also recommended for use on the DUT electronics. The TraceBox provides a common 2.54 mm pitch connector with isolated single-ended or differential SPI and UART interface.



  • Efficient master-slave network
  • Maximum data rate of 19.2 kbps
  • Robust and high noise immunity
  • Stable data transmission


LIN enables efficient communication between the TraceBox and the DUT. The LIN interface of the TraceBox is compliant to LIN specification 2.2A with a maximum data rate of 19.2 kbps. Due to the characteristics of LIN it allows a robust and high noise immunity for a stable data transmission.


(Coming Soon)



Go back